14. Why does it start, pump the water out, fill with water and then....nothing?
Tt makes a sound as though something is coming on, but looks like nothing the agitator never comes on. I tried to run it in test mode and have Code 2 along with delay/start hour blinking. Note the dispenser has been broken for years so we jut put the soap pod in with the cover open. Any way to test if this is a circulation motor issue for sure?
Dishwashers - Bosch
Answers & Comments
If you can connect to the circulation pump using a multi meter using the Ohm ? (resistance) setting, touching the 2 poles - and +, you can see if the motor is failing. If you get a current tester pen you can track the electricity along the wires to the circulation motor to see if the dishwasher is delivering power. If you remove the circulation pump you can have someone test it(by hooking it up to a direct power source). I had a similar issue and it was not the circulation motor, but the control board that failed.