16 Kw generac no power to the fuel solenoid
I checked for power on wire 14 the troubleshooting guide says replace the circuit board. I replaced the board and still have no power on wire 14
Electrical Supplies - Generac
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
Check wiring harness, solenoid should have power on cranking obviously. If you changed the board examine all wiring and ohm out the solenoid. Also did you check the old solenoid for a short? If not and it is shorted it is possible the new board has now gone. Most solenoids when they go bad, open so it isn't likely. Check wiring