For channel setup you will need to; 1) Connect the signal source to the back of the set.(Antenna or Cable) 2) Go into the TV Menu and select the same signal source you connected to the back.(Antenna or Cable) 3) Go to the auto program/scan menu and run it. This may take a few minutes.
Answers & Comments
For channel setup you will need to;
1) Connect the signal source to the back of the set.(Antenna or Cable)
2) Go into the TV Menu and select the same signal source you connected to the back.(Antenna or Cable)
3) Go to the auto program/scan menu and run it. This may take a few minutes.
Now the channels may be watched.