1990 prelude wont run right acts like 2 dead cylenders pull the plug wire on 4 it dies 1 it dies 3 it runs weaker 2 nothing just nothing just changed the injector and still nuthing
you covered everything but the dist. there may be a bad module or i think it is called an ignitor. You already said you plugged off the egr. check the dist shaft and see if it is worn out to where it wobbles. you covered everything but the dist. there may be a bad module or i think it is called an ignitor. You already said you plugged off the egr. check the dist shaft and see if it is worn out to where it wobbles.
The head gasket can be blown out between the two cylinder without dumping water into the oil pan. when you remove the head check the gasket you will see that the gasket is week in the middle between the two cylinders. no matter what you should go ahead and do a valve job and make sure you have the head shaved to enforce the sealing of the gasket.The head gasket can be blown out between the two cylinder without dumping water into the oil pan. when you remove the head check the gasket you will see that the gasket is week in the middle between the two cylinders. no matter what you should go ahead and do a valve job and make sure you have the head shaved to enforce the sealing of the gasket.
Answers & Comments
Do a compression test on all four cylinder to see if it has low compression. you may have a blown head gasket or burnt valve.
you covered everything but the dist. there may be a bad module or i think it is called an ignitor. You already said you plugged off the egr. check the dist shaft and see if it is worn out to where it wobbles.
The head gasket can be blown out between the two cylinder without dumping water into the oil pan. when you remove the head check the gasket you will see that the gasket is week in the middle between the two cylinders. no matter what you should go ahead and do a valve job and make sure you have the head shaved to enforce the sealing of the gasket.