1999 ezgo golf cart.need to know the whole wireing system for this cart. I put new batterys in and ihave a short somewhere cause know it want do nothing.the reverse beeper want come on nor will the cart move
When you removed the batteries, a certain procedure MUST be followed. Key switch off, switch to tow position and shift lever in reverse. You must wait until the beeper unit sound dies out then remove the wire from the most NEGATIVE cable. Place in Neutral before installing new batteries. There is a specific sequence to putting the batteries in an EZ-GO cart. Failure to follow this procedure will kill the controller. The Key switch must be off and the maintenance/tow switch MUST be in the tow position when connecting the batteries. Any of the above will cause the controller to fail, due to improper discharge of the PRE-Charge capacitors.
Okay, so I bought a 36 volt pds cart to rebuild. It came without batteries, so I don't know how they were removed. Is there a way to determine the controller condition?Okay, so I bought a 36 volt pds cart to rebuild. It came without batteries, so I don't know how they were removed. Is there a way to determine the controller condition?
Answers & Comments
When you removed the batteries, a certain procedure MUST be followed. Key switch off, switch to tow position and shift lever in reverse. You must wait until the beeper unit sound dies out then remove the wire from the most NEGATIVE cable. Place in Neutral before installing new batteries. There is a specific sequence to putting the batteries in an EZ-GO cart. Failure to follow this procedure will kill the controller. The Key switch must be off and the maintenance/tow switch MUST be in the tow position when connecting the batteries. Any of the above will cause the controller to fail, due to improper discharge of the PRE-Charge capacitors.
Okay, so I bought a 36 volt pds cart to rebuild. It came without batteries, so I don't know how they were removed. Is there a way to determine the controller condition?