DO NOT SMOKE OR CARRY LIGHTED TOBACCO OR OPEN FLAME OF ANY TYPE WHEN WORKING ON OR NEAR ANY FUEL-RELATED COMPONENT. HIGHLY FLAMMABLE MIXTURES ARE ALWAYS PRESENT AND MAY BE IGNITED, RESULTING IN POSSIBLE PERSONAL INJURY.
FUEL IN THE FUEL SYSTEM REMAINS UNDER HIGH PRESSURE EVEN WHEN THE ENGINE IS NOT RUNNING. BEFORE REPAIRING OR DISCONNECTING ANY OF THE FUEL LINES OR FUEL SYSTEM COMPONENTS, THE FUEL SYSTEM PRESSURE MUST BE RELIEVED TO PREVENT ACCIDENTAL SPRAYING OF FUEL, CAUSING PERSONAL INJURY OR A FIRE HAZARD.
Remove the 4 bolts (2 each side) and remove the skid plate if equipped.
Remove th1999 ford ranger fuel pump needs replaced. - e19f38e.gif pivot the fuel tank support straps away from the fuel tank.
Disconnect the fuel pump connector.
Disconnect the fuel pump
Lower the fuel tank.
1999 ford ranger fuel pump needs replaced. - b28c7f0.gif reverse the removal procedure
Special Tool(s)
REMOVAL
Clean the area around the fuel pump mounting flange.
Using the special tool, remove the fuel tank mounting surface.
Apply a light coat of Premium Long Life Grease XG-1-C or -K or equivalent meeting Ford specification ESA-M1C75-B to the gasket to hold it in position during assembly. Install the fuel pump mounting gasket.
Using the special tool, tighten the fuel pump assembly locking retainer ring.
Answers & Comments
Would it be easier to just take off the bed?
Hello!
- DO NOT SMOKE OR CARRY LIGHTED TOBACCO OR OPEN FLAME OF ANY TYPE WHEN WORKING ON OR NEAR ANY FUEL-RELATED COMPONENT. HIGHLY FLAMMABLE MIXTURES ARE ALWAYS PRESENT AND MAY BE IGNITED, RESULTING IN POSSIBLE PERSONAL INJURY.
- FUEL IN THE FUEL SYSTEM REMAINS UNDER HIGH PRESSURE EVEN WHEN THE ENGINE IS NOT RUNNING. BEFORE REPAIRING OR DISCONNECTING ANY OF THE FUEL LINES OR FUEL SYSTEM COMPONENTS, THE FUEL SYSTEM PRESSURE MUST BE RELIEVED TO PREVENT ACCIDENTAL SPRAYING OF FUEL, CAUSING PERSONAL INJURY OR A FIRE HAZARD.
- Disconnect the battery.
- Relieve the system pressure.
- Raise the vehicle.
- Drain the fuel tank.
- Disconnect the fill pipe hoses.
- Loosen fill pipe hose clamps.
- Disconnect fill pipe hoses from the fuel tank.
- Remove the 4 bolts (2 each side) and remove the skid plate if equipped.
-
- Remove th1999 ford ranger fuel pump needs replaced. - e19f38e.gif pivot the fuel tank support straps away from the fuel tank.
- Disconnect the fuel pump connector.
- Lower the fuel tank.
- Clean the area around the fuel pump mounting flange.
- Using the special tool, remove the fuel tank mounting surface.
- Apply a light coat of Premium Long Life Grease XG-1-C or -K or equivalent meeting Ford specification ESA-M1C75-B to the gasket to hold it in position during assembly. Install the fuel pump mounting gasket.
- Using the special tool, tighten the fuel pump assembly locking retainer ring.
REMOVAL
WARNING:
1999 ford ranger fuel pump needs replaced. - f3fcce3.gif/uploads/images/f3fcce3.gif" alt="f3fcce3.gif" />
Disconnect the fuel pump
1999 ford ranger fuel pump needs replaced. - b28c7f0.gif reverse the removal procedure
Special Tool(s)
REMOVAL