The problem is most likely with the hot water valve being stuck in the open position. Disable the hot water valve buy disconnecting the wires from its terminals then start cycle. The hot water valve is indeed stuck in the open position if the washer still fills with warm water; replace the hot water valve. Reverse the water valves, if the washer fills with right temperature, by interchanging their wires then start a cycle. The problem is with the motor controller module if the washer still fills with warm water or it is indeed the hot water valve if the washer fills cold water with the valves reversed.
The water valves are located under the console together with motor controller module and the display module. Remove the screws from the rear of the console then lift and tilt it to the rear of the washer to access the water valves.
The water valves are located under the console together with motor controller module and the display module. Remove the screws from the rear of the console then lift and tilt it to the rear of the washer to access the water valves.
Answers & Comments
The problem is most likely with the hot water valve being stuck in the open position. Disable the hot water valve buy disconnecting the wires from its terminals then start cycle. The hot water valve is indeed stuck in the open position if the washer still fills with warm water; replace the hot water valve. Reverse the water valves, if the washer fills with right temperature, by interchanging their wires then start a cycle. The problem is with the motor controller module if the washer still fills with warm water or it is indeed the hot water valve if the washer fills cold water with the valves reversed.
The water valves are located under the console together with motor controller module and the display module. Remove the screws from the rear of the console then lift and tilt it to the rear of the washer to access the water valves.