I have 2 mtx thunder 8000 4ohm speakers hooked up to the amp and they work until I bridge the amp then the volt meter on the dash goes down and the amp cuts off
Car Audio & Video - Power Acoustik - BAMF2200/2 Car Amp
I'd suspect that the amp is operating into too low of an impedance and going into protection.
The 2200/2 is not rated to drive a 2ohm load when bridged (most 2-channel amps aren't) and when you connect 2 4ohm subs in parallel, the load is 2ohms. I'd run one sub from each channel.
Wire ur sub down to 2 ohms and problem solved..go positive n negative on the speaker to the box then put the other plus and negative together..for dual voice coil...abra kadabra!!!
Answers & Comments
Hello munchisfun,
I'd suspect that the amp is operating into too low of an impedance and going into protection.
The 2200/2 is not rated to drive a 2ohm load when bridged (most 2-channel amps aren't) and when you connect 2 4ohm subs in parallel, the load is 2ohms. I'd run one sub from each channel.
Hope this helps.
Wire ur sub down to 2 ohms and problem solved..go positive n negative on the speaker to the box then put the other plus and negative together..for dual voice coil...abra kadabra!!!
Dont bridge it u ****!!!!! briding is ****!!!!