2000 Pontiac Sunfire , Cranks but won't start
I have a major screwed up issue, My friends car, a 2000 Pontiac Sunfire 2.2 had check engine light on, codes were a upstream O2 sensor and a Crank Position sensor, I replaced both , cleared the codes and drove car around , all was good . The other day they went to add Freon to the a/c unit and the car stalled and cranks but will not start, and the turn signal indicator lights on the dash are on steady , even with the key off. all happened at time of stall . So I brought my scan tool home from work to check for codes and such , plugged it into the car , hit the key and it fired up and ran, kinda rough but it was running , while i was getting into the live data to see what was going on the wire on my scan tool got super hot , I pulled the cable out of the obd2 connector and the car stalled and cranks but wont start . I replaced the PCM with a used unit today and everything is the same . I am at a loss and getting frustrated . Please help if you can .
Cars & Trucks - Pontiac
Answers & Comments
Have you checked for shorted wiring or burnt connectors at the PCM
Please use "comments" not "testimonial" to make comments. That said you can't test the PCM, you must diagnose by process of elimination. I think you MAY have a bad one. Good luck.