2006 isuzu nqr replace pass side caliber,pads ,and rotor I go to bleed the system no pressure at the pedal I true a vac pump to bleed still no pressuse I need help
What you need to do: -Make sure the brake recevoir is full of brake fluid. -Start the car and let it run and you need to pump the several time untill you get presure. -Lose and barely tight it back the bleeder bolt at the side that you just replace. (lose Only. Do not open!) -Use a Clear hose that fit to the bleeder bolt about 12" to 15". Connect it from the bleeder bolt to a glass jar or botle. -Ask a helper to press and hold, then you lose the bleeder to let fluid an d air come out. Then tight it back before release the brake pedal. (Over and Over untill you see no buble in the hose line) - Make sure brake fluid is full don't let it run out. -Now tight the bolt in place you should be good to go.
Answers & Comments
What you need to do:
-Make sure the brake recevoir is full of brake fluid.
-Start the car and let it run and you need to pump the several time
untill you get presure.
-Lose and barely tight it back the bleeder bolt at the side that you just replace. (lose Only. Do not open!)
-Use a Clear hose that fit to the bleeder bolt about 12" to 15". Connect it from the bleeder bolt to a glass jar or botle.
-Ask a helper to press and hold, then you lose the bleeder to let
fluid an d air come out. Then tight it back before release the brake pedal. (Over and Over untill you see no buble in the hose line)
- Make sure brake fluid is full don't let it run out.
-Now tight the bolt in place you should be good to go.
Mai Lor