2010 but it won't crank over with the start button, if you jump the solenoid it will crank over but it gets no fuel carbs are clean has no spark, any ideas?
Check the contact from the key, then the contact breaker (if there's power coming to it and if power is coming out to the solenoid). If there is then the problem is either in the solenoid or the high tension circuit. You could also try to check if fuel really enters the cylinder: crank the engine for a while then smell the spark plug - you should see and smell the gas.
This sounds like the clutch safety switch may need to be adjusted or replaced. Without it of course, it won't let you crank the engine and will shut off the ignition system. If it's fuel injected, it won't allow the injectors to pulse.
Please let me know what you find out and I will do my best to further assist you in this matter.
Answers & Comments
Check the contact from the key, then the contact breaker (if there's power coming to it and if power is coming out to the solenoid). If there is then the problem is either in the solenoid or the high tension circuit.
You could also try to check if fuel really enters the cylinder: crank the engine for a while then smell the spark plug - you should see and smell the gas.
Clearly it's a power issue - most likely at the contact key. Check it by jumping the wires directly at it.
This sounds like the clutch safety switch may need to be adjusted or replaced. Without it of course, it won't let you crank the engine and will shut off the ignition system. If it's fuel injected, it won't allow the injectors to pulse.
Please let me know what you find out and I will do my best to further assist you in this matter.
Sincere Regards,
Jason_MKG