318 engine starts good, idles good but when I put it in gear it feels like the tranny is locked in solid and the truck dies. If I do get it moving it will die at every stop. It feels like it wants to keep going, like it's not disengaging. What's the answer??
Probably a TCC (torque converter clutch) problem. When applied, this clutch makes a direct connection between the the engine crankshaft and transmission input shaft (just like a manual clutch). If it doesn't release, then it's just like coming to a stop but not pushing in the clutch with a manual transmission.
Several possibilities for the problem exist within either the electronic or hydraulic circuits, but quite often it's the TCC solenoid itself. If that's the case, then it's a relatively easy and inexpensive repair. Check for codes in the computer and go from there.
If you find this solution to be helpful, then please take a moment to rate this post. - Thanks.
Answers & Comments
Probably a TCC (torque converter clutch) problem. When applied, this clutch makes a direct connection between the the engine crankshaft and transmission input shaft (just like a manual clutch). If it doesn't release, then it's just like coming to a stop but not pushing in the clutch with a manual transmission.
Several possibilities for the problem exist within either the electronic or hydraulic circuits, but quite often it's the TCC solenoid itself. If that's the case, then it's a relatively easy and inexpensive repair. Check for codes in the computer and go from there.
If you find this solution to be helpful, then please take a moment to rate this post. - Thanks.