533 is not working on MS9337C+
At this time P4 2Ghz is working normally, but I failed to start P4 2.66GHz on MS9337C+.
Do you have any ideea to make Intel P4 2.66GHz/512/533 to start on MS9337C+ mainboard? Is it posible?
There are no jumpers to change mainboard speed.
BIOS: Phoenix Award BIOS v6.00 and I can not find a newer one. I failed to download BIOS from www.driverguide.com.
It a pitty Matsonic web page support is gone. Matsonic was a significant company during 2000-2002.
Do you have any ideea to make Intel P4 2.66GHz/512/533 to start on MS9337C+ mainboard? Is it posible?
There are no jumpers to change mainboard speed.
BIOS: Phoenix Award BIOS v6.00 and I can not find a newer one. I failed to download BIOS from www.driverguide.com.
It a pitty Matsonic web page support is gone. Matsonic was a significant company during 2000-2002.
Computers & Internet - Matsonic - MS9337c Motherboard
Answers & Comments
My cpu p4 2.66 pinless
#1. Does the CPU fan run if not then you may have a conductivity problem between fan and CPu. Did you use thermal paste or grease?
If fan is running follow directions below from my manual for MS9377C+ mainboard.
Go into the BIOS setup ,go to CPU setup, select proper voltage for you CPU. On Advanced setup page see if the hyperthreading function is revaeled. If so your CPU has this function. Set "Enabled " to test HT CPU function. If this doesn't work try "Disabling" the function. Good luck. I am about to attempt tp upgrade to a Prescott 3.0E which the box says this board supports. Sure hope so . Am running a 1.7 now.
[email protected]