Don't know what it goes to, it just says "engine 20amp' on fuse cover. Going to check harness for grounded wire? Seems if one was grounded it would blow fuse soon as it was replaced, rite?Don't know what it goes to, it just says "engine 20amp' on fuse cover. Going to check harness for grounded wire? Seems if one was grounded it would blow fuse soon as it was replaced, rite?
If the hot wire was grounded, yes, it would blow right away. But if it had to go threw an actuator or sensor It would not blow right away. With yours I would probably look at the transmission solenoid pack. Known problems with these. But again, I would see what this fuse supplied first.If the hot wire was grounded, yes, it would blow right away. But if it had to go threw an actuator or sensor It would not blow right away. With yours I would probably look at the transmission solenoid pack. Known problems with these. But again, I would see what this fuse supplied first.
Answers & Comments
What does the fuse supply voltage to? Could be a bad ground.
Don't know what it goes to, it just says "engine 20amp' on fuse cover. Going to check harness for grounded wire? Seems if one was grounded it would blow fuse soon as it was replaced, rite?
If the hot wire was grounded, yes, it would blow right away. But if it had to go threw an actuator or sensor It would not blow right away. With yours I would probably look at the transmission solenoid pack. Known problems with these. But again, I would see what this fuse supplied first.