ADP 4305. Where can I obtain a service manual?
Does not filling up with water. I can hear it is trying to fill but it then stop and give 1 flash every time. The dishwasher have no display panel. I turned it 45 degrees backwards. some water ran out but it is still doing the same. I check both the inlet and outlet hoses and could not see any damage. I tested the machine with the door open and with the filter in the middle. I could see that there is water coming through as the machine try every time to start in the hole where the filter goes. I also could see little bit of water going out via outlet
Dishwashers - Whirlpool
Answers & Comments
Thanks for the detailed description of the symptoms that we should make it easier fault detection.
I conclude that there is a mistake F1 (1 x flash,1s pause,1 x flash).
Before anything, erase the failures by pushing the START button for longer than 1.5 second.
F1 - NTC break
Temperature out of the normal value (-3°C till +85°C)Temperature inside higher than +85°CNTC defectiveDishwasher is frozen, less than -3°C If temperature is less than -3°C, fill the appliance with a cup of warm water to warm it up before you start it. The failures F1 (NTC break) and F9 (continuous water inlet) are checked and indicated immediately after start program. Because that, too small quantity water is taked.
First, I suggest to measure the resistance of the NTC, which must be about 58,1 kOhm at temperature 20°C. Also, check wiring between NTC and board.
Dado
Dear Dado thank you for replying... much appreciated! I emailed videos to the Fixya Team. Also a photo of the dishwasher parts to attach to my question. many thanks