After replacing drive belt, [954-0467], my troy bilt bronco won't fully stop, and the transmission control lever is difficult dto shift. When I turn off the ignition brake functions and shift lever shifts easily. my mower is 2008 model---------also, I have checked the belt routing, ok
The new belt is too tight.Look for an adjustment on the control lever or tension pulley.If that wont fix it.Remove the belt and take it to a NAPA.They can make you a new belt just 1/8 inch longer.I have had to do that with an old mower I had.
Answers & Comments
The new belt is too tight.Look for an adjustment on the control lever or tension pulley.If that wont fix it.Remove the belt and take it to a NAPA.They can make you a new belt just 1/8 inch longer.I have had to do that with an old mower I had.
Thanks for using Fix Ya,I hope this helps.