Amana af12538aes Refigerator No lights, ice, water
I've have this refrigerator for about a year and a half. I can hear the compressor kicking on. And the refrigerator and freezer are still cold.
But there is no lights when you open the doors to the refrigerator or freezer. And there is no lights / power to the Ice maker, water. temp controller pad on the front of the fridge
Refrigerators - Amana - AFD2535DES French Door Refrigerator
Answers & Comments
There's no ice If your ice maker has stopped producing ice completely, check these, in this order:
- It may be turned off. Look for the wire along the right side of the ice maker that looks a bit like a coat hanger. If the wire is in the raised position, the ice maker is turned off. If so, try one of these:
- If your ice maker has a small red plastic lever, lower it to lower the wire.
- If there's no plastic lever, simply lower the wire.
In either case, the ice maker should begin producing ice again. Also make sure that the temperature is 8 degrees Fahrenheit or lower. If the freezer is too warm, the ice maker won't cycle properly.
- The ice maker fill tube may be blocked with ice. If so, melt the blockage using a hair dryer-but be careful to not melt any plastic parts! Also replace the water shut-off valve or water-inlet valve, or both, if necessary.
- The ice maker head assembly may have broken parts. Look to see if the gears are broken. Check to see if the small plastic arms that rest against the ice rake are broken. If the ice maker head assembly is modular and you've found broken parts, you can just replace it.
Small or too few ice cubes If the ice maker is producing ice poorly--making small cubes or too few cubes--you probably have a clogged water line, a defective water-inlet valve, or a defective ice maker mold thermostat that isn't cycling properly. Check these:
- The water line that's attached to the back of the refrigerator. Make sure you have good water flow. If the flow is poor, repair, clean, or replace the tubing or the shut-off valve that supplies the water.
- The water-inlet valve. Replace it if it has failed.
- Check the freezer temperature. If should be 8 degrees Fahrenheit or lower. If the freezer is too warm, the ice maker won't cycle properly.
- The ice maker mold thermostat. Make sure that it's cycling properly.
Specks in the cubes If you find black or gray specks in your ice cubes, have a look at the ice cube tray. If the protective coating is peeling away, the most economical solution is to completely replace the ice maker.
You need to test wiring harness and connectors, and control board. Enter model number on link below the link below to find schematics and replacement parts.
Appliance Parts From PartSelect
Need help finding the model number on your appliance?
Look for the reset there should be a button somewhere near that panel. Also check the following or your own user manual.
Let me know
Hi!!! make you seem to have a control board problem.If your not getting 120 volts in the light socket then you have a board problem..good luck..check for loose wire at the control board.