1) Please go to under wood and put your work your software calibration under the hood and follow the step, for diagnostic and fix it.2) Adjust the reed switch by 1/8"3) tight the connector from display board vs lower board (main motor board(4) Measure 115 Vac for input to main motor board.5) Measure for +5Vdc for output for main motor board, to input to display board.6) Measure 115 Vca for main motor without load.7) Test the circuit breaker or fuse.8) Test the power supply coming from transformer for +5vdc.sincerely. Merry Christmas.ernesto cuadramanagua, nicaragua.
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
1) Please go to under wood and put your work your software calibration under the hood and follow the step, for diagnostic and fix it.
2) Adjust the reed switch by 1/8"
3) tight the connector from display board vs lower board (main motor board(
4) Measure 115 Vac for input to main motor board.
5) Measure for +5Vdc for output for main motor board, to input to display board.
6) Measure 115 Vca for main motor without load.
7) Test the circuit breaker or fuse.
8) Test the power supply coming from transformer for +5vdc.
sincerely. Merry Christmas.
ernesto cuadra
managua, nicaragua.