A small metal strip 2" long and 1/8" wide with two notches, one near one end and the other close to the middle, fell out of my machine while I was quilting. Any idea what it is and what I do about it?
These quite possibly be the balancing strips for the inside shaft i dont know how factory puts them on but im sure if you ran your machine at a higher speed it would start shaken if it does this would be your problem the other thing it could be is the sewing machines case strips on machine its self
Answers & Comments
These quite possibly be the balancing strips for the inside shaft i dont know how factory puts them on but im sure if you ran your machine at a higher speed it would start shaken if it does this would be your problem the other thing it could be is the sewing machines case strips on machine its self