Well you can right click the picture and save it to your desktop, I did it, but it was alittle blurry. But if this doesn't work for you, post me your email addy and I can send you a better picture. But take the top off, there are 6 screws, 3 on each side, remove the cap for the spinner, remember how the spinned and filter go back on before you re-install the cap, turn the smart mix valve half way so the piston doesn't come off, then pull the top off. replace the pump and remember which line goes where, make sure before putting the top back on that all lines are routed so as not to pinch. Start to put the top on, just before pushing it down, turn the smart mix vale to water only, then push it all of the way down. The cap for the spinned doesn't have to be real tight, sometimes you have to leave it just hand tight. Then turn it over and hook up the cogged belt again to the brush roll.