Blk wire on the inertia fuel shutoff switch why?
2005 ford taurus se 3.OL i check for volt at the inertia fuel shutoff switch what i need to check to find out why there is no volt?
Cars & Trucks - Ford
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
Hi,
sounds like you changed your fuel pump.
try hooking everything back up and spray some starting fluid in the intake while turning it over. for some reason ford engines have to be fooled back into starting back up. I did a mountaineer and had no power after a fuel pump change, tried starting fluid and voila.
i spray some gas in the intake while turning it over the engine start and run until it burn the gas in the intake but i don't hear the fuel pump run what i need to check now?
check for power at your relay, common for them to have the relay feed wire on the underside of the fuse box to burn off, re run a new heavier wire from the underside of the fuse box relay to switched/fused power side of fuse box