Bosch 4000 table saw needs rear motor bearing replaced. Parson repair shop shows picture of pulling the bearing without removing the motor. My question is this? How do you install the new bearing?
Remove the seal carefully. Remove the ring clip with needle nose pliers. Might be hard to see the clip so clean it out a bit. Bearing should just fall out. Replace with lots of new grease packed into bearing and put clip back in then seal
Answers & Comments
You don't need to remove the motor.thats fine
Remove the seal carefully.
Remove the ring clip with needle nose pliers.
Might be hard to see the clip so clean it out a bit.
Bearing should just fall out.
Replace with lots of new grease packed into bearing and put clip back in then seal