Also, check the screws just above the flywheels for the lower rotor. I found that mine where loose. Motor was spinning but not the blades. Tightened them up and was airborne in minutes.Also, check the screws just above the flywheels for the lower rotor. I found that mine where loose. Motor was spinning but not the blades. Tightened them up and was airborne in minutes.
Answers & Comments
Check the connection on the control board. The square plug may have come loose.
Also, check the screws just above the flywheels for the lower rotor. I found that mine where loose. Motor was spinning but not the blades. Tightened them up and was airborne in minutes.