Sounds like you have weak batteries or a bad brake. You can measure the brake resistance at the connector between the front and rear halves of the scooter. The brake is good if the resistance measures between 30 to 65 ohms. You should load test the batteries to see if they are good. It takes battery power to run the motor and release the brakes. Weak batteries will cause the brakes to drag and the scooter to run slow. A new brake costs about $70 and new batteries start at $40 each. If you do not have a beep fault code, nothing has burnt out yet. I would have the scooter checked out soon by a qualified technician. Hope this helps.
The brake is on the end of the motor and has a yellow release lever handle on it.The brake is on the end of the motor and has a yellow release lever handle on it.
Answers & Comments
Sounds like you have weak batteries or a bad brake. You can measure the brake resistance at the connector between the front and rear halves of the scooter. The brake is good if the resistance measures between 30 to 65 ohms.
You should load test the batteries to see if they are good. It takes battery power to run the motor and release the brakes. Weak batteries will cause the brakes to drag and the scooter to run slow.
A new brake costs about $70 and new batteries start at $40 each.
If you do not have a beep fault code, nothing has burnt out yet. I would have the scooter checked out soon by a qualified technician. Hope this helps.
Where is the brake at.
The brake is on the end of the motor and has a yellow release lever handle on it.