c works but when i turn on the heat it only blows cold in my 2000 ford mustang coupe
The heater valve door does open but we cant get the heat to work the a/c works grat and the heater coil is not cloged n theres a brand new thermastat in it as well if anyone has any suggestions plz let me know
Cars & Trucks - Ford - Mustang - 2000 Ford Mustang
Answers & Comments
Blender door actuator, under passenger side of the dash about 6 inches to the left "toward the center console" of the blower motor.
I’m happy to assist further over the phone at https://www.6ya.com/expert/brock_d67526d2a834c47e
Temperature Blend Door Actuator Lower the glove compartment. Disconnect the temperature blend door actuator electrical connector. Remove the 2 temperature blend door actuator screws. Remove the temperature blend door actuator. To install, reverse the removal procedure. Click image to see an enlarged view Fig. Temperature blend door actuator (2005 Models) Vacuum Control Motor-Air Damper Door Remove the instrument panel. Disconnect the vacuum hose. Remove the vacuum control motor. Remove the steel clip. Loosen the nuts. Click image to see an enlarged view Fig. Remove the vacuum control motor. To install: Installation is the reverse the removal procedure. Vacuum Control Motor-Air Inlet Duct Door Remove the instrument panel. Disconnect the vacuum hose. Disconnect the control arm. Remove the screws and remove the vacuum control motor. Click image to see an enlarged view Fig. Remove the screws and remove the vacuum control motor To install: Installation is the reverse the removal procedure. Lower the glove compartment. Disconnect the air inlet mode door actuator electrical connector. Remove the 2 air inlet mode door actuator screws. Remove the air inlet mode door actuator. Click image to see an enlarged view Fig. Vacuum control motor-air inlet duct door To install: Installation is the reverse the removal procedure.