1) Remove the four screws on the control box 2) Remove one screw from ground wires under box. 3) Use needle nose pliers to carefully remove the board. Easy access to fuse from there. 4) Replace fuse, calls for 4 amp I believe, should be ok to use a 6 or 8 amp. 5) Put back together and test.
Jugs support team very helpful, call if you get stuck.
Fuse is in control ..Hard to get to I cut the section of the box out to get to fuse figured its going to blow often i was cleaning the wheel with a wet sponge when my fuse blew first week.
Answers & Comments
1) Remove the four screws on the control box
2) Remove one screw from ground wires under box.
3) Use needle nose pliers to carefully remove the board. Easy access to fuse from there.
4) Replace fuse, calls for 4 amp I believe, should be ok to use a 6 or 8 amp.
5) Put back together and test.
Jugs support team very helpful, call if you get stuck.
Fuse is in control ..Hard to get to I cut the section of the box out to get to fuse figured its going to blow often i was cleaning the wheel with a wet sponge when my fuse blew first week.