Cancel Light Flashing on Kitchen Aid Dishwasher
Have a Kitchen Aid dishwasher, model KUDR02FSSS3. The "Cancel" light continues to blink or the "Normal" and "Light China" lights flash back and forth. The other restets for the KUDI series do not work.
Any ideas?
Thanks
Dishwashers - KitchenAid - 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher
Answers & Comments
I ran into this same problem. Cutting the power didnt reset it.
After power reset, mine had the normal led blinking. If I pressed cancel, then the cancel and china button leds would start blinking too.
I pulled out the trouble shooting guide (from behind the baseboard kick panel under the dishwasher door). It that if the dishwasher wont run and button LEDs are blinking there is a short circuit in the keypad. It gave a keypad diagnostic sequence which I followed. (disconnect keypad and try to initiate the diagnostic cycle without the keypad by disconecting the yellow leads to OWI sensor twice in less than 6 seconds.
I could hear the diagnostic cycle start, so the problem is a bad keypad. Will order a new one tomorrow and let you know if it works.
My next test will be disconnecting the key pad orange leads and try reset timer
Hi 1cassie1,
Did you try to turn the power off at the breaker box?
This resets the whole system usually!
Let me know how it goes? Write me back!
Other wise you need a hands on tech.
ngafm
please give me a rating before you sign off!
yes i did and the problem still the same