Cannot light new burners
I have just replaced the burners on my three burner ducane but now they will not light. there is gas getting to the burners and the ignition jets it is as if there is too much gas getting to the burners
Grilling - Ducane - 30400040 Stainless Steel Grill
Answers & Comments
I just replaced my burners and I also cleaned the starters. Get a wire brush about the size of a tooth brush to clean the starter, the thing that makes the spark to start the flame.
Compare the old burners to the new. Good chance the variable opening is larger than the original. This adjusts the mixture (fuel vs air). Loosen the screw & close the gap. On mine I had to close it as much as possible. Reinstall.
If the burner is only paritially lit or the flame runs up and down the tube on high but is good on low, you need to close the mixture even further.
To save time just work on one burner until it is adjusted properly. Then set the others to the same gap size.