Cant get the old blade off
Laser husky tile saw 950i. Is their a switch like a skill saw has on it to stop the blade from turning in order to wrench it off? If so where is the trigger to keep it from spinning? If not what should I do to change the blade? To keep the blade from turning to put a wrench on it?
Measuring Tools & Sensors - Husky - Wet Tile/Stone Saw with with Laser and Stand
Answers & Comments
Should be a blade lock button, if not i clip vise grips on mine let the table keep the blade from turning put wrench on nut and tap wrench with hammer see if ya can loosen nut good luck billy
On the bottom of the black motor housing there is a button. The button is facing the water tray. Push the button in and spin the blade around until the button presses in and the blade will lock up. Now just loosen the nut and remove/replace the saw blade.
very helpful thank you