If (this?) is a large capacity draw then check to see if there is a small hole in the back of the machine on the same level as that of the paper draw. Power off the machine then stick a screw driver into the hole, there is a spring release for manual release. If this is a small tray then you can disconnect the draw from the copier 4 screws and plates (If installed:() dont for get the cable connection middle back of machine, recommeded two people lift
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f
Answers & Comments
If (this?) is a large capacity draw then check to see if there is a small hole in the back of the machine on the same level as that of the paper draw. Power off the machine then stick a screw driver into the hole, there is a spring release for manual release. If this is a small tray then you can disconnect the draw from the copier 4 screws and plates (If installed:() dont for get the cable connection middle back of machine, recommeded two people lift
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f