Clutch slave cylinder
I changed out a clutch on my 1993 dodge dekota slave cylinder canot be bled and dosnot leak and when you push the clutch and put it in gear theres barly any presher on peddle gos into gear easy exsept reverse and tires spin at first then stop like the clutch not engaging any idies
Cars & Trucks
Answers & Comments
Hi Tony,
Typically what happens is the master cylinder went dry. The most reliable way to make it work is to PRE BLEED the master cylinder and then start again.
Go to the parts store and pick up a MC bleed kit. This has little hoses and fittings. You disconnect the line out of the mc, and hood the hose in, and route the other end under the surface level of the fluid in the mc reservoir. Pump until no more bubbles.
FROM This point, be certain that the mc does not run out of fluid!!!.
Hook up the hose and commence bleeding the line and slave cylinder.