Computer won't boot back up after power failure!
I have tried several different options in the bios, including "STATS".
The computer is used in an unattended location. I need for my computer to power up and boot without human intervention. One of the bios power options allows the computer to power up, but requires that the "F1" key ne pressed to continue. What am I doing wrong?
Rich...
Computers & Internet - Biostar - M7NCD ULTRA Motherboard
Answers & Comments
If you have a windows cd run it thru and reset the settings ,,,, also you may go to system restore 1st and back date it to before it started acting that way ,,, some software or something was loaded to mess with your bios / please remember to give your rating / thanks
Hello sir!!
Please keep pressed the F8 button while u power up the the PC and select the safe mode and enter into the desktop. later u can restore the system!
You better replaced the CMOS battery. it need to be replace so that it will not erased the previous settings made into the cmos/bios
Can you explain what it satys on the screen please
go into the bios and select "power management setup" then select "Power-On by Alarm" annd set it to "enabled" after that you have to set the time and date you want the computer to boot itself, see screenshot:there is no need to change anymore settings, so press F10, save and exit.
The computer will then wake up at the time you specified
this should help
regards
give it a trial run to see if it does what you want it to