Copier all of a sudden doesn't recognize paper tray. Thus, message says "out of paper", but when I put the tray back in, it says 'no tray'. A former colleague did something so that paper would feed into the machine, and said no one can fill the tray completely with paper. Now someone has gone and done that. Any recommendations?
Did you try a reset? If not then refer to page 147 of the manual below http://www.brother.ca/en/products/pdf/manuals/MFC8860DN-UG.pdf Also make sure that you have enable the MP tray mode page 104
Answers & Comments
Did you try a reset? If not then refer to page 147 of the manual below
http://www.brother.ca/en/products/pdf/manuals/MFC8860DN-UG.pdf
Also make sure that you have enable the MP tray mode page 104