covers the inverter board of a NEC 2010x. Ive got all the plastic off, but I'm hesitating on which screws need to be removed to get the LCD off the back, is it the 4 on each corner. is that a safe move. I've worked on tube monitors, so I'm not exactly a novice, but I hate to go in via the wrong direction and mess up the delicate cabling I'm seeing. Thanks in advance
Softgoods, The 4 screws could need to be removed to gain acess to the SMPS/INVERTER board. could be an answer if you find a vid on youtube or give a call to "buddymc" at his www.ccl-la.com/badcaps.htm website.I personally try NEVER to remove the front plastic "BEZEL" from any lcd panel if possible. Just be very, very careful when removing the ventillated metalwork frame to gain access!! Be certain no printed circuit boards are attached to the frame when removing it. Document with "stills" so you can get it back together without extra parts on bench. 12fixlouie
Answers & Comments
Softgoods, The 4 screws could need to be removed to gain acess to the SMPS/INVERTER board. could be an answer if you find a vid on youtube or give a call to "buddymc" at his www.ccl-la.com/badcaps.htm website.I personally try NEVER to remove the front plastic "BEZEL" from any lcd panel if possible. Just be very, very careful when removing the ventillated metalwork frame to gain access!! Be certain no printed circuit boards are attached to the frame when removing it. Document with "stills" so you can get it back together without extra parts on bench. 12fixlouie