Creda Solarglo I am replacing a couple of elements in the hob. Everything is fine apart from the fact that the wiring connectors on the new rings are completely different. Where do the old wires go on the new unit? Richard
Ovens - Creda
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
Hi
Please follow these instructions for oven element replacement--
Remove 4 screws at each corner of the backplate. Carefully remove oven light cover. Unscrew the oven lamp cover first before unscrewing the 4 retaining screws. Jiggle it around the side panels protrusions. Remove element by unscrewing the screw between the two points where the element goes in. The screw also has a washer between its head and the element plate. The element lifts off the retaining brackets at the base. Bring forward carefully as the connection wires will be attached to the element. They should just slide off with a little coaxing...or maybe with the use of some pointed pliers. Make sure the connecting wires don't disappear back down the holes! Assemble in reverse manner.
Also check the slide show on flicker---
Creda oven element replacement
Hope this helps... Please post back if you need more information.
Daniel