If your experiencing a none complete clucth disengagement, pedal to the floor and hard to engage the trans into any gear, bleed the hydralic clutch system, no air in it, thats not the issue, than you have a defective pressure plate not releasing the clutch disc, it's what we call a hang up disc syndrum, have not seen issue with the release brg, what you can by is parts to fix this, Dynapac might have a listing, if not visit your Chrysler dealer. GOOD LUCK. RDJRP
"IF" you can pull the boot around the clutch release lever back enough. to shine a small flash light into the hole, Have someone shoot some P.B.Blaster(available at most hardware stores) "behind" the throw-out bearing and onto the splined shaft behind that. Avoid getting any spray on the clutch disk or the pressure plate work it back and forth. It might take a couple tries, but this should work.
Answers & Comments
If your experiencing a none complete clucth disengagement, pedal to the floor and hard to engage the trans into any gear, bleed the hydralic clutch system, no air in it, thats not the issue, than you have a defective pressure plate not releasing the clutch disc, it's what we call a hang up disc syndrum, have not seen issue with the release brg, what you can by is parts to fix this, Dynapac might have a listing, if not visit your Chrysler dealer. GOOD LUCK. RDJRP
"IF" you can pull the boot around the clutch release lever back enough. to shine a small flash light into the hole, Have someone shoot some P.B.Blaster(available at most hardware stores) "behind" the throw-out bearing and onto the splined shaft behind that. Avoid getting any spray on the clutch disk or the pressure plate work it back and forth. It might take a couple tries, but this should work.