When changing label rolls, check the paper sensor position - also might be helpful to use canned air to blow out any mysterious pieces of paper that can block the sensor's view of your label stock.
Then calibrate the printer. Press and hold "FEED" until the printer cycles 8-10 times. Let go. Printer should say Calibration Complete and you should be good to go.
Answers & Comments
When changing label rolls, check the paper sensor position - also might be helpful to use canned air to blow out any mysterious pieces of paper that can block the sensor's view of your label stock.
Then calibrate the printer. Press and hold "FEED" until the printer cycles 8-10 times. Let go. Printer should say Calibration Complete and you should be good to go.
Please post more details.