DCS Built in Double Oven
I am getting a continuous beeping sound and an error code of F-7 on the Display panel. I had this problem once before and my manual told me how to solve it. I cannot locate my manual. Can you help.
Ovens - DCS - WO-230 Electric Double Oven
Answers & Comments
WHAT IS WRONG WITH YOUR RANGE / STOVE / OVEN?
For a detailed Range/Stove/Oven illustration, click below.
Gas Free Standing
Electric Free Standing
Click this link get manual
http://www.retrevo.com/s/DCS-WOS-230-review-manual/id/886dj888/t/1-2/
thanks for fixya
always turn off the circuit breaker first.
Open the oven door (if you have a double oven, it should be the upper
one) and remove three screws (on some models just two on corners) from
the bottom of the control panel. If the control panel on your oven is
made of stainless steel, then you have to pull the oven out of the
cabinet for about 2′ to 3′ to get better access. Pull the control panel
forward and up to remove the tabs on the top of the frame, out of the
holes in the end caps. Pull the control panel out and turn it about 90°
toward yourself (the face of the control panel down). Unplug the
control panel ribbon from the ERC. Remove four screws holding the ERC
to the control panel. On some models you also have to remove the screw
which attaches the ground wire to the control panel. Let the ERC hang
on its wires, remove the old control panel and replace it with the new
one. On some models before you do it, you have to remove the end caps
and the bottom shield from the old control panel and install them on
the new one. Do not forget to plug the new control panel ribbon into
the ERS slot. Attach the new control panel to the oven and turn the
circuit breaker on.
always turn off the circuit breaker first.
Open the oven door (if you have a double oven, it should be the upper
one) and remove three screws (on some models just two on corners) from
the bottom of the control panel. If the control panel on your oven is
made of stainless steel, then you have to pull the oven out of the
cabinet for about 2′ to 3′ to get better access. Pull the control panel
forward and up to remove the tabs on the top of the frame, out of the
holes in the end caps. Pull the control panel out and turn it about 90°
toward yourself (the face of the control panel down). Unplug the
control panel ribbon from the ERC. Remove four screws holding the ERC
to the control panel. On some models you also have to remove the screw
which attaches the ground wire to the control panel. Let the ERC hang
on its wires, remove the old control panel and replace it with the new
one. On some models before you do it, you have to remove the end caps
and the bottom shield from the old control panel and install them on
the new one. Do not forget to plug the new control panel ribbon into
the ERS slot. Attach the new control panel to the oven and turn the
circuit breaker on.