delete old existing codes as page 7 of my manual indicates. I now actually now have 3 codes which unlock the lock! I need to remove access from a code holder, and prefer to erase them all now. Thanks so much for the help! :)
Locks & Locksmithing - Weiser Lock - Powerbolt 1000 Lock
Answers & Comments
How do I change the access code (and delete my old code) on my Powerbolt 1000?
- Manually put the bolt in the extended (lock) position. Press the PROGRAM button once, enter your new 4 - 8 digit code and then press the LOCK button.
- Press the PROGRAM button twice, enter the same new code and then press the LOCK button once.
- Press the PROGRAM button three times, enter the same new code and then press LOCK once.
The steps below are to change your access code to a new code. This will also remove any previous codes stored in the Powerbolt's memory.
If your old code still remains in the unit, you will need to perform a hard reset of the unit. To perform a hard reset of the unit, remove all four batteries and leave them out for 1 hour. After the hour has passed, you may re-enter the batteries.
United States of America Customer Service Contact Information
Call Us Toll Free: 800-422-4278 (Mon-Fri, 6:00am - 4:30pm PST)
http://www.weiserlock.com/Support/Faq/50160000000HhhZAAS.aspx
Good luck, Elizabeth!