Hi my nameis Mike Houston of DISH Network and I see where you want the code for theMintek DVD-1600 to program to the DISH Network remote. We currently do not have any codes for theMintek DVD player; I will send a link to help with a Power Scan, http://www.dishnetwork.com/SupportSection/power-scan-instructions.
You may want to search for the code by performing a Power Scan, I will include the steps below. If this doesn't resolve this there is most likely a compatibility issue. Power Scan: 1.) Press and hold the correct VCR button (about six seconds) until all mode button backlights come on, then release. 2.) Press 500 pound (#) 3.) With the desired equipment on, press and hold the VCR/DVD button until all mode button backlights illuminate (about 3 seconds), then release. 4.) Press and release the Power button. 5.) Press the Up button once a second while pointing the remote at the desired equipment. If the code for the equipment comes up, the equipment will power off. 6.) Press the POUND (#) button. If the code entered is valid for the remote, the mode light flashes three times. To verify the code works try several different functions for that equipment.
are the buttons in step 1 and 3 the same button because that is what I understood but you do refer to buttons differently and I'd like to be sure b4 I try this. -kare the buttons in step 1 and 3 the same button because that is what I understood but you do refer to buttons differently and I'd like to be sure b4 I try this. -k
Answers & Comments
Hi my nameis Mike Houston of DISH Network and I see where you want the code for theMintek DVD-1600 to program to the DISH Network remote. We currently do not have any codes for theMintek DVD player; I will send a link to help with a Power Scan, http://www.dishnetwork.com/SupportSection/power-scan-instructions.
You may want to search for the code by performing a Power Scan, I will include the steps below. If this doesn't resolve this there is most likely a compatibility issue.
Power Scan:
1.) Press and hold the correct VCR button (about six seconds) until all mode button backlights come on, then release.
2.) Press 500 pound (#)
3.) With the desired equipment on, press and hold the VCR/DVD button until all mode button backlights illuminate (about 3 seconds), then release.
4.) Press and release the Power button.
5.) Press the Up button once a second while pointing the remote at the desired equipment. If the code for the equipment comes up, the equipment will power off.
6.) Press the POUND (#) button. If the code entered is valid for the remote, the mode light flashes three times.
To verify the code works try several different functions for that equipment.
Daniel Busa
DISH Network
Customer Service
are the buttons in step 1 and 3 the same button because that is what I understood but you do refer to buttons differently and I'd like to be sure b4 I try this. -k