Bottom, but the manual mentions a couple different procedures. See below.4.1L Engine Before servicing the vehicle, refer to the Precautions section. Remove or disconnect the following: Negative battery cable Steering gear and linkage assembly Harness connector Starter retainers Starter To install: Install or connect the following: Starter Starter retainers. Tighten the starter retainers to 30-37 ft. lbs. (40-50 Nm). Harness connector Steering gear and linkage assembly Negative battery cable Alternate procedure: Remove or disconnect the following: Negative battery cable Engine undercover Harness connectors Starter motor mounting bolt and nut Remove engine mounting insulator bottom nuts, and lift engine approximately 2 inches with a transmission jack Remove starter motor To install: Installation is in reverse order of removal; observe torque values shown in diagram Fig. Starter motor mounting and torque specifications-Q45 & 2004 M45
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
Bottom, but the manual mentions a couple different procedures. See below.
- Before servicing the vehicle, refer to the Precautions section.
- Remove or disconnect the following:
- Remove or disconnect the following:
- Remove engine mounting insulator bottom nuts, and lift engine approximately 2 inches with a transmission jack
- Remove starter motor
- Installation is in reverse order of removal; observe torque values shown in diagram
4.1L Engine
Negative battery cable Steering gear and linkage assembly Harness connector Starter retainers Starter
To install:
Install or connect the following:
Starter Starter retainers. Tighten the starter retainers to 30-37 ft. lbs. (40-50 Nm). Harness connector Steering gear and linkage assembly Negative battery cable
Alternate procedure:
Negative battery cable Engine undercover Harness connectors Starter motor mounting bolt and nut
To install:
Fig. Starter motor mounting and torque specifications-Q45 & 2004 M45