A gas flowmeter can be find at any welding store, I will recommend Praxair (check you local praxair store they are located worldwide), they have a house label called Prostar*, it is very inexpensive with great quality. A flowmeter will cost you less than 100 bucks.
If this was useful to you please vote. ThanksHi: A gas flowmeter can be find at any welding store, I will recommend Praxair (check you local praxair store they are located worldwide), they have a house label called Prostar*, it is very inexpensive with great quality. A flowmeter will cost you less than 100 bucks. If this was useful to you please vote. Thanks
Answers & Comments
Hi:
If you are using solid mild steel core wire, yes you need a mix of gas Argon/CO2 75/25.
Only cored shielded wire do not required gas (also called innershield or flux cored).
Adjust your flow rate for the mild steel wire at 20 or 25 scfh, depending if you are welding inside or outside a shop.
I need a flowmeater for my clark 180. Where can I find one ?
Hi:
A gas flowmeter can be find at any welding store, I will recommend Praxair (check you local praxair store they are located worldwide), they have a house label called Prostar*, it is very inexpensive with great quality. A flowmeter will cost you less than 100 bucks.
If this was useful to you please vote. Thanks