Drivers side door will not catch when door is closed it will just bounce away. the door handle does not seem to be as spring loaded as passenger side thanks
Look on the end of the door and you will see the slot where the door catch is located. It should line up with a big stud sticking out from the post by the drivers seat. The gap should be open. If you see a piece of steel blocking the slot, then the door catch is already in the latched position. Insert a screwdriver into the bottom of that catch and pull it up into the open position. If that is the problem, the door will work after that. Hope that helps
Answers & Comments
Did you try squirting some WD-40 in the latch? Might be sticking.
Look on the end of the door and you will see the slot where the door catch is located. It should line up with a big stud sticking out from the post by the drivers seat. The gap should be open. If you see a piece of steel blocking the slot, then the door catch is already in the latched position. Insert a screwdriver into the bottom of that catch and pull it up into the open position. If that is the problem, the door will work after that. Hope that helps