Dynex tv model number DX-40L261A12 tv will not come on at all I unplugged it to try and reset it but it won't work. The red power light is on but every time I push the power button it does nothing
Televison & Video - Dynex
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
Leave it unplugged for an hour and try again. Use the remote to turn it on. If the power button doesn't work then you may need the remote .
Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
http://electro-medical.blogspot.com/
In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.
Before going further; try a hard reset first. If it does not help you, replace the main digital board. There are two methods to reset TVs. The first is simple to do; a Hard Reset. The other is somewhat skilled; is a Factory Reset (System Reset). To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. If you do this by overnight is better. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; visit the site linked here.