Echo SRM 210 Weedeater won't rev high enough anymore to cut good
I have an Echo SRM 210 weedeater , I have been using this for 3 1/2 yrs for my lawn serv. I took the screen out of the muffler the first week I got it. It wont rev up high enough to cut good anymore.I replaced the spark plug and the fuel filter and have a clean air filter. Any other things I can do to get it back running good? Please Help
Garden - Echo
Answers & Comments
Sounds like a carberator issue when a gas engine won't rev. Either that, or bad gas, or even an old spark plug.
Try a new spark plug first since that's easiest. Get the recommended spark plug for that model.
Then, if your gas is old (from last year) drain it and put some fresh gas in.
Make sure the head where the cutting line comes out spins freely and isn't bound up with old grass.
Check Your exhaust port.. not the muffler itself the actual port. More than likely carbon and Soot has built up clogging the port significantly. It commonly does this after a few to three years of use. Usually caused by to much two cycle oil added to the gas and just carbons debris building up from combustion.
Hope this helps because it sure helped me ????????????
Check Your exhaust port.. not the muffler itself the actual port. More than likely carbon and Soot has built up clogging the port significantly. It commonly does this after a few to three years of use. Usually caused by to much two cycle oil added to the gas and just carbons debris building up from combustion.
Hope this helps because it sure helped me ????????????