ECM Giotto group gasket and shower plate falling out
I have an ECM Giotto and just yesterday the group gasket and shower plate fell out of the group head. I cleaned it and pressed it back in, but it fell out again. How do I install this so it stays in the group head?
Thanks!
Steve
Thanks!
Steve
Coffee Makers & Espresso... - ECM - Giotto Espresso Machine
Answers & Comments
I am assuming that you have basket style shower which sits in the gasket and then inserts in the group.
Find the small bevel edge on the gasket, make sure that side is facing up, place gasket on table then insert shower in gasket, then lift gasket, until it sits at the top of the shower(use a small flat screwdriver or a small hard brush to clean the group where the gaskets seats), then insert gasket and shower in group. Push in as far as you can then use the portafilter to seat the gasket in all the way.
If your shower is the flat style then there should be a hole in the middle for a screw.