EOC-3220ext Loosing its wired connection with lan
I have 4 EOC-3220ext with firmware 1.41.05. One or the units is wired to a router with internet access and is configured in AP mode and WDS is enabled with the other 3 units Mac address The other 3 units are set the same as the first same channel 9 and SSID NET and in each of the other 3 WDS has the first units Mac address. ip addresses, internet router 192.168.168.254. first wired EOC-3220ext 192.168.168.250 and the other 3 EOC-3220ext 251 to 253 This setup is working 6 weeks. this week the wired unit keeps dropping its connection with the router. I have changed the units around replaced power supply and re-wired but still the same problem I have a wired or wireless connection with EOC-3220 192.168.168.251. I can log into Eoc-3220 192.168.168.250 but nothing else I can go to EOC 3220 192.168.168.252 log into it and log into EOC 3220 192.168.168.250 and nothing else If there was a fault with my internet router or cat5 cable to the the first EOC3220 I should be able to log into one of the EOC's and see all the others Also if I connect to the router I can log into all the eoc's The only fix is to power down the router and EOC wired to it for 1 hour power up again and everything is fine again for a few hours
Computers & Internet - EnGenius - EOC-3220 (EOC3220)
Answers & Comments
I have a similar setup with same problems. Senao 3220ext wired to Linksys router which is also a gateway. I have not been able to configure it to work with my Dlink AP2100. only Senao indoor with WDS works with it and disconnects after a few pinging. someone said its compatibility but i feel i have not done something right, DOES ANYONE KNOW HOW This configuration can be done?