All Eurotech washers need 2-4 minutes to relieve the vacuum which creates the watertight seal at the doorduring the washing period. After the final spin cycle has stoped please exercise a little patience and wait this 2-4 minutes before attempting to open the washer door. Failure to observe this might result in damage to your washer unit.
Hello Welcome to fixya. I'm Huuum and happy to assist you,
You said, after load finished door did not automatically open.
How old is the washer? Treat it like an error code. This can reset the system. Turn the breaker off to cut the power for 5 minutes. Then restart the breaker and try the range. It's like rebooting your computer when its acting strange! Usually it corrects some error problems if they are not serious. Or they are sometimes just a glitch.
If this does not remedy the problem, then the switch itself is bad. Let me know how it works out.
Please remember to leave a rating before you go! Thank you
Answers & Comments
All Eurotech washers need 2-4 minutes to relieve the vacuum which creates the watertight seal at the doorduring the washing period. After the final spin cycle has stoped please exercise a little patience and wait this 2-4 minutes before attempting to open the washer door. Failure to observe this might result in damage to your washer unit.
Hello
Welcome to fixya.
I'm Huuum and happy to assist you,
You said, after load finished door did not automatically open.
How old is the washer?
Treat it like an error code.
This can reset the system.
Turn the breaker off to cut the power for 5 minutes.
Then restart the breaker and try the range.
It's like rebooting your computer when its acting strange!
Usually it corrects some error problems if they are not serious.
Or they are sometimes just a glitch.
If this does not remedy the problem, then the switch itself is bad.
Let me know how it works out.
Please remember to leave a rating before you go!
Thank you