F1 shows on control panel of both drawers,after a couple of startup.Even when machine is not being used both drawers startup on F1,only way to control is to shut off at main supply
Dishwashers - Fisher and Paykel - DD605SS Stainless Steel Dishwasher
Hi Thanks for using FixYa. F1 error means that the flood switch has been activated.You’ll need to reset it by powering off the breaker or by unplugging the unit from the power socket and mains for more than five minutes. Please check that there is no blockage in the drain hose and it is not raised higher otherwise the water will run back to the dishwasher. Also perform the following procedure---
Unplug power and remove bottom dish drawer
Use a Sponge and dry all the excess water underneath
Remove circuit board cover
Dry all around and underneath as much as possible
Apply hairdryer for 10-15min
Please do rate the solution if the issue is resolved or else revert for further assistance. Thanks Rylee
Answers & Comments
Hi
- Unplug power and remove bottom dish drawer
- Use a Sponge and dry all the excess water underneath
- Remove circuit board cover
- Dry all around and underneath as much as possible
- Apply hairdryer for 10-15min
Thanks for using FixYa. F1 error means that the flood switch has been activated. You’ll need to reset it by powering off the breaker or by unplugging the unit from the power socket and mains for more than five minutes. Please check that there is no blockage in the drain hose and it is not raised higher otherwise the water will run back to the dishwasher. Also perform the following procedure---
Please do rate the solution if the issue is resolved or else revert for further assistance.
Thanks
Rylee