The only sure way recommended (and probably the safest) would be to get a service manual or at least a schematic diagram. The Fantom Cyclone XT was originally manufactured by Fantom Technologies, Inc. that closed in October 2001. The replacement for a Fantom Cyclone XT would be Westinghouse Wired Deluxe Edition (either a WST1550 or a WST1551). These replacement products are now handled by Salton Inc. Perhaps you may inquire from them:
Salton Inc.
1 800 616 8689
[email protected]
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards. Thank you for using FixYa.
Answers & Comments
Hi,
- Salton Inc.
- 1 800 616 8689
- [email protected]
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
The only sure way recommended (and probably the safest) would be to get a service manual or at least a schematic diagram. The Fantom Cyclone XT was originally manufactured by Fantom Technologies, Inc. that closed in October 2001. The replacement for a Fantom Cyclone XT would be Westinghouse Wired Deluxe Edition (either a WST1550 or a WST1551). These replacement products are now handled by Salton Inc. Perhaps you may inquire from them:
Good luck and kind regards. Thank you for using FixYa.
I think the manual can help you in replugging the wires
How did you pull out the wires from circuit board ?
Is it with professional help or through some other means